...
| Table of Contents | ||
|---|---|---|
|
Installation via Native driver
⚠️ Connect the printer to your computer only when prompted by the installer
Install the XID Native driver (available in the Matica product page for your specific printer)
When requested connect the printer back to your machine
Optionally install the
Job Monitor(Prompted during installation)
Installation via EDIsecure Connect
In order to install a XID Series printer from Matica, you’ll need to install the EdiSecure EDIsecure Connect utility
This tool can be downloaded HERE
Extract the files and follow the steps provided during the setup process
After installing, under the Start menu, you should have a folder named
EdiSecure EDIsecure ConnectorMatica(depeding depending on the installed version) with the tools available to be used
...
Under the Start menu, open the
EdiSecure EDIsecure Connect/Maticafolder and then click onAdministration Center/Device Configurator
...
Return to the Start menu, and in the
EdiSecure EDIsecure Connect/Maticafolder open theDispatcher/Job Monitor. Here you’ll be able to check if the printer is properly detected, its status and job queue.
...
If correctly recognized it will be displayed with a green icon above it signalling that the printer is ready to work
...
Troubleshooting
...
Some users have reported that during this step the Matica XID 8300 DS appears in the Dispatcher/Job Monitor but instead of displaying a green icon it stays greyed out.
To solve this issue follow these steps
...
Disconnect the printer from your computer
...
Return to the Administration Center/Device Configurator and on the left hand panel select Delete Group. This will remove the configured printer
...
Install the following driver Matica XID Driver 8.0.1
...
When requested connect the printer back to your machine
...
Printing & Encoding
Printing without encoding
...