/
MAGICARD 600 ETHERNET CONNECTION

MAGICARD 600 ETHERNET CONNECTION

In order to setup the Magicard 600 via Ethernet, please follow the steps below.


Step 1.

With the printer disconnected, remove the base molding.

Step 2.

Disconnect the reader USB from CN5 and connect it to CN31 or CN35.

Step 3.

Put the base molding back in the printer and connect it via Ethernet.

Step 4.

Install the driver ( Magicard Windows Printer Driver ) on the driver installation, choose Modify if you already have a printer driver, select the printer model and select the driver installation  for Ethernet connection.

Step 5.

Once the installation is complete open Producer, go to printer options and the reader to use is the one with the name Magicard.






The Twn4 works over ethernet using the factory firmware in the Magicard test tool.

 

Related content

Windows 11 Supported Devices in CardExchange Producer
Windows 11 Supported Devices in CardExchange Producer
Read with this
Magicard TWN4 Encoder Installation bootloader versions lower than (1.50)
Magicard TWN4 Encoder Installation bootloader versions lower than (1.50)
More like this
Tech note 19_04_Install_Elatec_TWN4_ZebraZC_Magicard
Tech note 19_04_Install_Elatec_TWN4_ZebraZC_Magicard
More like this
Technote 19/01 - Matica printers installation
Technote 19/01 - Matica printers installation
More like this
TWN4 bootloader versions (1.50+) Encoder Installation
TWN4 bootloader versions (1.50+) Encoder Installation
More like this
Matica XDI 8300 encoder installation and setup
Matica XDI 8300 encoder installation and setup
More like this