/
Tech note 19_04_Install_Elatec_TWN4_ZebraZC_Magicard

Tech note 19_04_Install_Elatec_TWN4_ZebraZC_Magicard

TWN4 Installation

Technote 19/06 (year/number)

Date: June 12th, 2019

Author: Rui Paulino

Applicable Products: CardExchange® Producer & CardExchange® Visitor

TWN4 firmware and driver installation

 

In order to have the TWN4 reader being recognize correctly will be needed to install its drivers and then update its firmware to the version TWN4_NCx320_PRS104_Nano_CDC_Simple_Protocol.

To install its driver is needed to have the printer connected to the computer through USB and have its driver installed in beforehand.

Next, please go to the Elatec folder available in the link below and go to Driver folder and run the bat file that is there.

Elatec TW4



The firmware update must be done using the Elatec tools to be more precise the AppBlaster.

 

 

After these steps please open the app Director from Elatec and check if you can connect to the reader, if so it means the firmware and the driver was correctly installed and it will be recognized in CardExchange as Elatec TWN4.

If you have any further questions or doubts, please don’t hesitate to contact us using the details on the footer of the technote.

Related content

Technical Notes
Technical Notes
Read with this
TWN4 bootloader versions (1.50+) Encoder Installation
TWN4 bootloader versions (1.50+) Encoder Installation
More like this
Supported Printers
Supported Printers
Read with this
Magicard TWN4 Encoder Installation bootloader versions lower than (1.50)
Magicard TWN4 Encoder Installation bootloader versions lower than (1.50)
More like this
Print Server Error Messages
Print Server Error Messages
Read with this
Technote 19/01 - Matica printers installation
Technote 19/01 - Matica printers installation
More like this